Hw 130 Motor Control Shield For Arduino Datasheet Free Hot!

// Reverse at full speed digitalWrite(MOTOR1_DIR, LOW); analogWrite(MOTOR1_PWM, 255); delay(2000);

Provides 0.6A per bridge (1.2A peak) with thermal shutdown protection.

Proper power management is critical for the HW-130 to avoid resetting the Arduino or damaging components. hw 130 motor control shield for arduino datasheet free

| Shield Label | Arduino Pin | Function | | :--- | :--- | :--- | | (Motor Power) | Vin (7-12V) | Supplies power to motors (pass-through from Arduino barrel jack) | | GND | GND | Common ground | | B-IA | Digital Pin 4 | Control signal for Motor B (Input A) | | B-IB | Digital Pin 5 | Control signal for Motor B (Input B) | | A-IA | Digital Pin 6 | Control signal for Motor A (Input A) | | A-IB | Digital Pin 7 | Control signal for Motor A (Input B) |

The (frequently referred to as the L293D Motor Shield V1) is a versatile expansion board designed for the Arduino Uno and Mega. It serves as a comprehensive "plug-and-play" solution for controlling up to four DC motors , two stepper motors , and two 5V hobby servos simultaneously. HW-130 Technical Specifications It serves as a comprehensive "plug-and-play" solution for

Built-in pull-down resistors to keep motors disabled during power-up. Integrated reset button for the Arduino board. Internal kickback protection diodes. Pinout and Control Logic

// Accelerate from 0 to full speed for (int speed = 0; speed <= 255; speed++) analogWrite(M1_SPEED, speed); delay(20); Internal kickback protection diodes

The HW-130 Motor Control Shield offers several advantages over other motor control solutions, including: