: With a pair of fine-tipped tweezers, Leo bridged the two specific test points. The Detection
Last updated: October 2025 – Compatible with AE-Tool v3.2.1 and above. Realme C1 rmx1811 test point AE-Tool
| Error | Solution | |-------|----------| | Device not detected | Reinstall MTK VCOM drivers, try another USB port (USB 2.0 preferred) | | Keeps disconnecting | Hold the short a little longer (4-5 seconds) | | DA mismatch error | Use the DA file from AE-Tool’s “MTK_AllInOne_DA.bin” | | Auth file required | Patch DA with AE-Tool or use Miracle Box instead | : With a pair of fine-tipped tweezers, Leo
Since the Realme C1 is a Qualcomm device, a standard "Meta Mode" (common for MediaTek) is not applicable; instead, you must use the Test Point method to trigger EDL Mode (9008 Port). Hardware Prep : You must disassemble the phone to access the motherboard. Shorting the Points Hardware Prep : You must disassemble the phone
For the , the test point is used to force the device into Qualcomm EDL (Emergency Download) Mode (9008 Port) . This is necessary for deep-level operations like flashing firmware, bypassing FRP (Factory Reset Protection), or removing screen locks when the device is bricked or locked. Test Point Location
The AE-Tool often requires you to set the voltage switch to 1.8v . Unlike standard EDL (Emergency Download Mode) methods that use two test points near the battery connector, ISP requires direct soldering to these specific small pads on the PCB. Execution Steps for AE-Tool